18k Rose Gold Plated Opal Set Ball Labret Stud - 1.2mm (16 Gauge)
|This is a 316L Surgical Steel Labret stud for 1.2mm (16 gauge) piercings such as lip, monroe or pierced ears. It comes with a stunning synthetic Opal ball set into the steel. |
It is 18k Rose Gold plated in finish.
They are available in either 8mm or 10mm so please make sure that you order the correct size for your piercing. (See our measuring guide for help)
These opal labret studs look stunning in lots of different piercings and are bound to get comments from people about how pretty they are.
Measuring Your Piercing - Jewellery Measuring Guide
Wearing the correct size of body jewellery is very important. If you wear a size that is too small it could easily irritate or hurt your piercing. If your jewellery is too big it can easily catch your clothes resulting in a damaged piercing.
The measurements to consider with each piece of jewellery are as follows:
Length / Diameter of the jewellery. (A / B in the diagram above)
The above example pictures show you the measurements that you need to take for a Banana Bar, a Ball Closure Ring (BCR), a Barbell and a Labret. Only measure a piece of jewellery that currently fits you correctly.
An alternative method is to directly measure your piercing between both holes using a ruler, although this can sometimes be difficult on your own.
Thickness / Gauge of the jewellery (C in the diagram)
The most common sizes are as follows:
* Navel, Tongue and Nipple jewellery - 1.6mm (or 14 Gauge)
* Eyebrow - 1.2mm (16 Gauge)
* Nose - 1.0mm (18 Gauge)
* Labret piercings are usualy either 1.2mm (16 Gauge) or 1.6mm (14 Gauge)
These are the the standard thicknesses of body jewellery that we sell, so unless you have an unusual piercing, you do not have to worry about this measurement.
We often get asked what are the sizes of jewellery in my country. In Europe thickness is shown in mm but in other parts of the world people use gauge. The following table should help you convert the sizes.
* 1mm = 18 gauge
* 1.2mm = 16 gauge
* 1.6mm = 14 gauge
* 2mm = 12 gauge
* 2.4mm = 10 gauge
* 3.2mm = 8 gauge
* 4mm = 6 gauge
* 5mm = 4 gauge
* 6mm = 2 gauge
* 8mm = 0 gauge
* 6mm = 1/4"
* 8mm = 5/16"
* 10mm = 3/8"
* 11mm = 7/16"
* 12mm = 1/2"
* 14mm = 9/16"
* 16mm = 5/8"
* 18mm = 11/16"
* 19mm = 3/4"
* 21mm 13/16"
Crystal and Materials Colour Charts
Please note that these colours are shown to give an indication of the colour of the jewellery but slight colour variations do occur occasionally. Not all designs are available in all colours.