Tribal Dream Large Gauge Segment Ring
|Until now Large Gauge Segment rings can be very hard to open and close as they require special pliers and the larger the gauge the harder they are! We have a solution with these Tribal Dream segment rings. They are basically 2 parts that are held together with 2 screws. They will require a screwdriver to fit and remove which is not included with the item.
They are 316L Surgical Steel and are also available Gold plated or Rose Gold plated.
They are available in 7mm, 8mm (0 gauge), 10mm (00 gauge), 12mm (1/2") or 15mm in either 12mm, 15mm or 19mm internal diameter (not all combinations are available)
Measuring Your Piercing - Jewellery Measuring Guide
Wearing the correct size of body jewellery is very important. If you wear a size that is too small it could easily irritate or hurt your piercing. If your jewellery is too big it can easily catch your clothes resulting in a damaged piercing.
The measurements to consider with each piece of jewellery are as follows:
Length / Diameter of the jewellery. (A / B in the diagram above)
The above example pictures show you the measurements that you need to take for a Banana Bar, a Ball Closure Ring (BCR), a Barbell and a Labret. Only measure a piece of jewellery that currently fits you correctly.
An alternative method is to directly measure your piercing between both holes using a ruler, although this can sometimes be difficult on your own.
Thickness / Gauge of the jewellery (C in the diagram)
The most common sizes are as follows:
* Navel, Tongue and Nipple jewellery - 1.6mm (or 14 Gauge)
* Eyebrow - 1.2mm (16 Gauge)
* Nose - 1.0mm (18 Gauge)
* Labret piercings are usualy either 1.2mm (16 Gauge) or 1.6mm (14 Gauge)
These are the the standard thicknesses of body jewellery that we sell, so unless you have an unusual piercing, you do not have to worry about this measurement.
We often get asked what are the sizes of jewellery in my country. In Europe thickness is shown in mm but in other parts of the world people use gauge. The following table should help you convert the sizes.
* 1mm = 18 gauge
* 1.2mm = 16 gauge
* 1.6mm = 14 gauge
* 2mm = 12 gauge
* 2.4mm = 10 gauge
* 3.2mm = 8 gauge
* 4mm = 6 gauge
* 5mm = 4 gauge
* 6mm = 2 gauge
* 8mm = 0 gauge
* 6mm = 1/4"
* 8mm = 5/16"
* 10mm = 3/8"
* 11mm = 7/16"
* 12mm = 1/2"
* 14mm = 9/16"
* 16mm = 5/8"
* 18mm = 11/16"
* 19mm = 3/4"
* 21mm 13/16"
Crystal and Materials Colour Charts
Please note that these colours are shown to give an indication of the colour of the jewellery but slight colour variations do occur occasionally. Not all designs are available in all colours.